4.6 (461) In stock
Hello, I recently bought a Printrbot Play, and I’m experiencing some problems with my first layer. The first layer looks acceptable for small objects, but when I print some bigger objects (with a greater surface) it just looks terrible. As you can see on the picture, it looks like the infill is way to big to fit inside the perimeters of the first layer. It is actually crossing the bottom perimeter, and causing the layer to “wave”. The small square on the left has this issue also, but less
Troubleshooting 3D prints, first layer issues
Přímá viditelnost Milovaný Děkuji 3d print first layer issues lékárna Start zbytky
pla - Expansion in bottom skin after first layer - 3D Printing Stack Exchange
bottom layer looks terrible - 3D Printing / 3D Printers - Talk Manufacturing
7 main factors in getting the perfect 3D printing first layer・Cults
Přímá viditelnost Milovaný Děkuji 3d print first layer issues lékárna Start zbytky
First layer has thin and thick areas. - Improve your 3D prints - UltiMaker Community of 3D Printing Experts
3D Print Stuck to Bed: What to do?
🔥 The definitive guide to solving 3D printing problems by Bitfab - Bitfab