4.5 (174) In stock
Hey everyone, Beginner here 🙂 Which config parameters should I play with to avoid this first-layer issue? (this is in standard speed)
3D Printer Troubleshooting Guide
Best Support Settings for 3D Printing : 9 Steps (with Pictures) - Instructables
Poor first object layer after supports - Troubleshooting - Bambu Lab Community Forum
Bambu Studio Fine Tuning: Tips And Tricks For X1 And P1P
How to Prevent Infill Marks on the Surface of your Pieces
Spaghetti after perfect first layer - Troubleshooting - Bambu Lab Community Forum
First layer problem : r/BambuLab
What causes this first layer issue? - Troubleshooting - Bambu Lab Community Forum
Problem with first layer inspection - Bambu Lab X1 Series - Bambu Lab Community Forum
First layer not good on Bambulap P1P - Bambu Lab P1 Series - Bambu Lab Community Forum
First layer adhesion issues. Thoughts? : r/BambuLab
First Layer Defects : r/BambuLab
Sudden X1C Print Quality Issues - Troubleshooting - Bambu Lab Community Forum