New to printing. My model came out with really thick supports. And

Epson EcoTank ET-8500 - Photo Review

Printing with supports – How do I print this? (Printing help

New to printing. My model came out with really thick supports. And it's a huge pain to remove. Any tips I've been at it for about an hour with little progress.

Help with why 3d print has a big long hole? - Technical Problems

Why your resin printer only prints supports and no model, and how

UltiMaker Cura 5.4 adds updated tree supports, better brims, and

Do I need to add supports?

print quality - Difficult to remove support material - 3D Printing

Thinner areas if support is printed, solution? : r/AnycubicVyper

Printer is scraping the first couple layers without going up? Is that normal? Also, is there a way to reset the print head position so it's not laying in the Plattform?

Adjusting FDM print settings - GrabCAD Help Center

Help Please. My print keeps missing chunks. : r/resinprinting

MUTOH Introduces The New ValueJet 1628MH─The Most Versatile

Thick Wall (6 loops) Fails at 45 Degree Angle - Troubleshooting

Printer is scraping the first couple layers without going up? Is that normal? Also, is there a way to reset the print head position so it's not laying in the Plattform?