First layer / callibration issue (Prusa i3 - Slic3r)

Hello, I am in the process of tuning my newly built Prusa i3 and I have some issue finding the right parameters to tweak in order to fix some issues with the infill of my first layers. I am using Repetier firmware/host and Slic3r 0.9.10b. The basic calibration seams quite ok and I am getting very u

Prusa I3 mk3 - Not your average inconsistent first layer - 3D

Prusa I3 mk3 - Not your average inconsistent first layer - 3D

Issue with first layer calibration (V2Calibration) – Prusa i3 kit

Prusa i3 MK3S+ first layer issues : r/3Dprinting

Why is the First Layer via the First Layer Calibration better than

Optimizing Print Quality on a Prusa MK3S – Iowa Scaled Engineering, LLC

First layer issues Prusa Knowledge Base

Slic3r Manual – Print Settings

Prusa XL Goes Big, But That's Only Half The Story