First Layer Issues - Troubleshooting - V1 Engineering Forum

Looking for someone who has experienced this before. When I am printing parts with a large surface area/bottom layer, I keep having this issue. Smaller parts print great. It just seems when it extrudes long lines along the bed right next to each other it has issues. It’s hard to say that is a bed adhesion problem if you were to watch it closely as it went. It’s not that each line isn’t sticking to the bed, but it looks like as the next line comes back beside it tends to peel up the previous lin

First layer issues with intricate patterns – Assembly and first

How to Make the Perfect 3D Print First Layer

First Layer Issues - Troubleshooting - V1 Engineering Forum

3D Printing Layer Issues - Advice - V1 Engineering Forum

First layer problem : r/BambuLab

First Print - Troubleshooting - V1 Engineering Forum

Well, I'm getting started! - Troubleshooting - V1 Engineering Forum

First Layer Issues : r/FixMyPrint

First layer issues : r/ElegooNeptune4

Large ASA prints warping - Bambu Filament and Accesories - Bambu

Irregular first layer problem – How do I print this? (Printing

First Layer problems - Inconsistency – Assembly and first prints

V1 Engineering Inc -V1E.com

First Print - Troubleshooting - V1 Engineering Forum

First Layer Problems – Assembly and first prints troubleshooting