4.9 (163) In stock
Hello, I've printed a ton of PLA since I've got my MK3S two years ago, but barely any PETG. I'm starting now, and I'm noticing some first layer issues
PETG (PolyLite) Adhesion Poblems / Wobbly Brim - Troubleshooting
How to achieve a fully filled in first layer – How do I print this
How to help mitigate petg string/blobs : r/3Dprinting
PETG (PolyLite) Adhesion Poblems / Wobbly Brim - Troubleshooting
7 problems affecting the quality of your 3D prints - Original
Under extrusion first layer – General discussion, announcements
PETG Cheatsheet: Choosing the Best Slicer Settings
Makergeeks PETG issuesHELP! - Filament - LulzBot
CPE / PETG terrible first layer & surface quality - Materials
SOLVED] Bad quality when printing PETG - Bambu Lab X1 Series
pla - Randomly underextruding/overextruding small part on CR-10
Sudden top layer problems – Hardware, firmware and software help
First layer issues - Prusament PETG – How do I print this
Overture PETG, is this over extrusion? Only happens on thinner
Gap between wall lines on PETG : r/FixMyPrint