4.9 (462) In stock
I’m printing directly on the build platform (V2) and am having trouble getting the height of the parts close to size. I started with the default settings and my part came out 0.9mm too high. I adjusted the z compression correction to 0.0mm and my part is still 0.2mm too high. How to I adjust it further to compensate? Also, how do I avoid the edge highlighted in the second image where the part sits on the build plate? Thanks. (I’m printing directly on the platform for speed of print and surfac
Prints resolution/distortion in area of supports and surfaces facing platform - Form 3/3+ - Formlabs Community Forum
PDF) A Short Review on 4D Printing
s41205-023-00197-5, PDF, Young's Modulus
Remove Raft layer when using the No Raft setting and still needing supports - Feature Requests & Ideas - Formlabs Community Forum
Instruments, Free Full-Text
Why are first layers so different in 0.1 & 0.05mm layer height? - Form 3/3+ - Formlabs Community Forum
DDL2021 Digital Proceedings by info-ddl-conference - Issuu
Automated 3-D Printed Arrays to Evaluate Genotoxic Chemistry: E-Cigarettes and Water Samples
Dental Asia January/February 2021
Sensors, Free Full-Text
Resin pooling on top side of parts adding 0.5 mm to height - Form 3/3+ - Formlabs Community Forum