41FL-8 Dixon Valve Brass SAE 45 deg. Flare Fitting - Long Nut - 1/2 T — HoseWarehouse

$ 4.50

4.5 (620) In stock

41FL-8 Dixon Brass SAE 45 deg. Flare Fitting is a Long Nut, and has a 1/2" Tube Size x 3/4"-16 Straight Thread. The economical fitting resists mechanical pullout, and is manufactured especially for hard to hold liquids and gases.

Features:
Reference SAE 010111. Long nut offers additional vibration capacity. Economical fitting resists mechanical pullout. Easy to disassemble and may be reassembled repeatedly, for a leak-proof connection. Manufactured from CA 360, CA 345, or CA377 brass. Manufactured especially for hard-to-hold liquids and gases.
Specifications:
Listed with Underwriter's Laboratories for flammable liquid, marine, refrigeration and gas applications. Meets functional requirements of SAE J512 and J513, ASA and MS (Military Standards). Temperature range: -65 deg. F to 250 deg. F Working Pressure Ranges: Temperature and type of tubing used are important factors, the table below is a good guide for proper selection. The PSI rating given is based on a temperature of 73 deg. F using copper tubing.
Assembly Instructions:
Cut tubing squarely and clean tube end thoroughly to remove burrs. Place nut onto tube. Place threaded end of nut toward end of tube. Flare tube end with flaring tool to provide 45 deg. flare. Clamp tube flare between nut and nose of fitting body by screwing nut on finger-tight. Tighten with a wrench an additional 1/4 turn for a metal-to-metal seal.

Working Pressure Ranges:

PSI	Tube OD	Tube Wall
1400	1/4	.030
1000	3/8	.032
750	1/2	.032
650	5/8	.035
550	3/4	.035

Part Number	Tube Size	Straight Thread	Hex	PSI	Min/Max Temp	Material	Weight (Lbs)
41FL-4	1/4	7/16-20	9/16	1400 (95.24 bar)	-65 deg. F / 250 deg. F (-53.89 deg. C / 121.11 deg. C)	Brass	0.0400
41FL-6	3/8	5/8-18	3/4	1000 (68.03 bar)	-65 deg. F / 250 deg. F (-53.89 deg. C / 121.11 deg. C)	Brass	0.0800
41FL-8	1/2	3/4-16	7/8	750 (51.02 bar)	-65 deg. F / 250 deg. F (-53.89 deg. C / 121.11 deg. C)	Brass	0.1300

SAE 45° Inverted Flare, Brass Fittings

Dixon push-on fitting are intended for use with Lok-On (push-on style) hose only No hose clamps or ferrules are needed Lok-On fitting will properly

Dixon Valve BPN42 Brass Push-On Hose Fitting, 1/4 Male NPTF x 1/2 Push-On Hose ID Barbed

Brass Flare Fittings – Flare Forged Nut, Flare Union, Flare Tee, Flare Elbow, Flare Connectors, Flare Cap, Flare Branch Tee, Reducing Flare Union, Flare Plug, Flare Long Nut, Flare Union Elbow, Flare